Jnled.net

Dual lamp marine LED searchlights, 200W to 600W

A dual lamp marine LED searchlight puts two lamp heads on a single endless-rotation mount, so you get the output of both from one mounting point. The JNLED series runs from 200W to 600W, is dimmable across the range and has an adjustable beam angle. Three models are published: the Double 200W, the Double 380W and the Wand double 600W. Standard housing colours are black, white and grey. Units are built to order, so the finish and the mounting are fixed against your drawing before production starts.

When to specify two lamp heads instead of one

Specify the dual lamp series when one fixture has to do two jobs, or when the mounting position is fixed and you cannot add a second light.

The adjustable beam angle lets you open the beam to wash a lock wall or a quay edge, then close it down for long-throw work during a search. Endless rotation means the head keeps turning in one direction without an end of travel, so an operator can follow a target through a full circle and keep going. Dimming brings output down for close work alongside, which keeps reflected glare off the bridge windows and protects the crew’s night vision.

If the position only needs a single head, the single lamp 180W marine LED searchlight offers the same adjustable beam and continuous rotation at lower output.

What the dual lamp configuration gives you

Seven things that decide the specification on a marine searchlight, and how this series handles each one.

Output from 200W to 600W

The series spans the range, so you can vary wattage by mounting position without changing supplier or fixture type across the vessel.

Adjustable beam angle

Set the spread to the task instead of choosing between a flood and a spot at order time. The same fixture covers area wash on deck and long throw over water.

Endless rotation

The head turns continuously in one direction with no end stop, so tracking a moving target never runs out of travel.

Dimmable across the series

Run at full output for search and rescue, then dim for mooring, loading and close manoeuvring.

50,000 to 100,000 hours rated life

JNLED LED platforms are rated in this band. That matters when the fixture sits high on a mast and access means dry dock or a lift.

Up to 70% less energy than traditional lighting

Less draw on the vessel’s supply. Send us your existing fixture schedule and we will run the cost-saving calculation against it.

Components you can name in a submittal

Philips Lumileds and Nichia LEDs with Mean Well drivers. We buy direct from the chip, driver and coating suppliers.

Dual lamp series specification

Series output

200W to 600W

Published models

Double 200W, Double 380W, Wand double 600W

Beam

Adjustable beam angle

Rotation

Endless, continuous in one direction

Control

Dimmable across the series

Housing colours

Black RAL 9011, White RAL 9016, Grey RAL 9006

Ingress protection

Not published for these models. JNLED housings run from IP65 to IP68 across the catalogue, so confirm the rating for yours with us.

Efficacy

Up to around 100 lm/W, quoted per product. Not published for these models; ask us for the figure.

Rated life

50,000 to 100,000 hours across JNLED LED platforms

LEDs and drivers

Philips Lumileds and Nichia LEDs, Mean Well drivers

Warranty

Confirmed in writing with your quotation

Supply

Built to order, shipped worldwide

Vessels and operations crews use these searchlights on

Inland river vessels

Locks, canal banks and bridge approaches on night transits, where the beam moves constantly between the bank and the water ahead.

Ocean-going vessels

Entering and leaving port, deck work at anchor, and searching open water when someone goes over the side.

Harbour tugs

Line handling and made-fast work alongside, where the crew needs light on a moving target close to the hull.

Power boats and search and rescue

Output and the ability to hold a target through a full rotation matter more here than anywhere else on the list.

Ports, marinas, locks and docks

Berthing and unberthing after dark, and lighting the working area during loading and unloading.

How JNLED specifies, builds and ships the order

JNLED has manufactured LED lighting from Hong Kong since 2010. We hold our own moulds on key lines and buy direct from the chip, driver and coating suppliers. Sitting close to the factories in South China means we work with them directly on product development, so we can change a housing, a beam or a coating for a project instead of selling you the nearest catalogue item.

Send us the vessel, the space or the lux target. We return a light-simulation report and a cost-saving calculation against your current fixtures. From there we cover project design, production, logistics including customs clearance and warehousing, installation support and worldwide shipping.

For engine rooms, tank decks and other hazardous areas, specify from our ATEX and IECEx explosion-proof range rather than from a searchlight series.

Ask about the dimmable 200W to 600W dual lamp series

Tell us the vessel, the mounting position and the wattage you have in mind. We come back with a model recommendation, a light-simulation report and a costed bill of materials.

JNLED, Unit G, 15/F TAL Building, 49 Austin Road, Kowloon, Hong Kong SAR
info@jnled.org | +852 6123 9127